Ontario Regulation 278/05 specifically names deteriorating pipe insulation as a Type 3, friable material, the classification that requires full enclosure and, in many cases, continuous air monitoring. We assess the condition of the wrap on site before recommending the level of containment your project actually needs.
Mechanical rooms and basements are often still in use during a project. We plan containment to work around that instead of shutting the whole space down by default.
Steam and hot-water heating pipes in older Ottawa homes and buildings were commonly wrapped in asbestos-containing insulation.
Deteriorating pipe wrap is a Type 3 friable material under Ontario Regulation 278/05, requiring full enclosure and continuous air monitoring.
We contain the entire mechanical room or basement area, not just the section of pipe being worked on.
We assess the condition of the pipe wrap – deteriorating material requires stricter controls.
For friable material, we set up full enclosure and, where required, continuous air monitoring.
Pipe insulation is removed section by section using controlled methods.
Air monitoring results and clearance documentation confirm the space is safe before reuse.
Intact versus deteriorating material changes the containment plan.
Type 3 material gets the highest level of controls.
Work is scoped to the pipe runs that actually need it.
Air monitoring results confirm the space is safe.
Pipe insulation is priced per linear foot after an on-site assessment, since the condition of the material (intact versus deteriorating) significantly affects the containment required.
Priced per linear foot
Final rate depends on pipe access, material condition, and whether full enclosure is required
Request a free on-site assessment for an exact quote
Pipe insulation is priced per linear foot of pipe rather than by area, and the containment required depends heavily on whether the material is intact or deteriorating, so we assess on-site before quoting.
Deteriorating pipe insulation is specifically classified as a Type 3, friable material under Ontario Regulation 278/05, meaning it releases fibres more readily and requires the highest level of containment and air monitoring.
Yes, though depending on the material's condition, we may need to fully enclose the work area and, in some cases, recommend the space stay unoccupied until clearance is confirmed.